Protec Epoxy Primer AP4110
2 pack adhesion promoting epoxy primer.
Protec Epoxy Primer is a 2-pack adhesion-promoting epoxy primer designed for use over bare metal surfaces and under spray polyester and hand-applied body fillers to protect against corrosion.
It has excellent adhesion to steel, aluminium, fibreglass and zinc-coated metals.
Product
Protec Epoxy Primer AP-4110
Protec Epoxy Primer Hardener AH-4120
Paraglaze Reducer Low Temp PS-6100
Paraglaze Reducer Standard PS-6200
Paraglaze Reducer High Temp PS-6300
Carmaster GP 2 Pack Reducer CS-3800
Protec Heavy Duty Wax & Grease Remover AA-6822
Protec Methylated Spirits 207
Substrates and Preparation
Protec Epoxy Primer can be applied over the following substrates once they have been prepared as follows:
Substrate Preparation
Bare Steel Degrease with AA-6822 Protec Heavy Duty Wax and
Grease Remover, condition with 971-9119 Metal
conditioner and Degreaser, abrade with Startline P240 (dry).
Aluminium Startline P240 – P320 (dry), then use a 50:50 mixture of
Water and 207 Protec Methylated Spirits with one rag to
wipe on and another clean rag to wipe off.
Prime within 6 hours.
Zinc Coated Alloys Startline Scourer with a 50:50 mixture of Water and 207 Protec Methylated Spirits.
Zinc-coated metals can vary in alloy composition,
therefore, it is recommended that an adhesion test is
carried out before completing any major work.
GRP & Fibreglass Startline P240 – P320 (dry)
Do not apply acrylic lacquer primers and topcoats over or under AP-4110 Protec Epoxy Primer.
Substrates other than those stated above should be tested before use, to ensure that the performance of this product is suitable for its intended use.
Cleaning
Before and after any sanding operation, the substrate must be thoroughly degreased using AA-6822 Protec Heavy Duty Wax & Grease Remover.
Product specification sheet
Protec Epoxy Primer AP4110 product specification sheet opens in a new windowManufacturer
Protec
