Paraglaze Prime and Fill PP3860
2 pack acrylic urethane quick drying high build primer.
Paraglaze Prime & Fill is a two pack acrylic urethane quick drying high build primer designed for use where a high build is required over repair areas.
It can also be used as a primer surfacer and offers excellent sanding and gloss holdout and can also be tinted with Paraglaze Gloss (PT-G) tinters.
It is recommended for use under Paraglaze Basecoat and Paraglaze Gloss.
Products
Paraglaze Prime & Fill – PP-3860
Paraglaze Hardener Low Temp – PH-4100
Paraglaze Hardener Standard – PH-4200
Paraglaze Reducer Low Temp – PS-6100
Paraglaze Reducer Standard – PS-6200
Paraglaze Reducer High Temp – PS-6300
PROTEC® Flex Additive – AA-5656
Protec Heavy Duty Wax & Grease Remover – AA-6822
Substrates & Preparation
Paraglaze Prime & Fill can be applied over the following substrates once they have been prepared as follows:
Substrates Preparation
Sound OEM finishes and sound, fully cured 2 pack refinish finishes STARTLINE® P240 – P320 (dry)
Small areas of bare steel Startline P240 – P320 (dry)
New electro-coated panels Startline P240 – P320 (dry)
GRP & Fibreglass Startline P240 – P320 (dry)
Plastics Protec Plas Stik Primer – where recommended in the AP4880 / AP-4990 Technical Data Sheet
Large areas of bare steel and areas where polyester body filler will be applied should be coated first
with AP-4110 Protec Epoxy Primer (faster option) or PP-3450 Paraglaze CT 2K HP Epoxy Primer –
Grey or AP-4441 Protec Etch Primer.
Substrates other than those stated above should be tested before use to ensure that the performance of this product is suitable for its intended use.
Cleaning
Before and after any sanding operation, the substrate must be thoroughly degreased using AA-6822
Protec Heavy Duty Wax & Grease Remover.
Product specification sheet
Paraglaze Prime and Fill PP3860 product specification sheet opens in a new windowManufacturer
Protec
