Chocfast Red SG Chocfast Red SG

Three-component, high strength, 100% solids, epoxy grouting compound.

Chockfast®

Red SG is a three-component, high strength, 100% solids, epoxy grouting compound, which is used to grout large machinery and to support soleplates in all types of foundation designs.

Chockfast®

Red SG has extremely high compressive strength and negligible shrinkage, making it ideal for the final positioning of critically aligned machinery within close tolerances.

Chockfast®

Red SG has the following advantages when compared to conventional cement grouts:

• Impervious to oil
• Cures at least three times as quickly
• No mixing ratios to measure
• Grouts machinery in final aligned position
• Higher physical strength
• High impact strength
• Resistance to many more chemicals
• Strong bond to metal and concrete
• Unaffected by weathering and freeze/thaw cycling
• Stated physical properties assured
• Superior resistance to fatigue

Chockfast®

Red SG contains no non-reactive diluents which could interfere with the curing mechanism or which could cause material loss during or after cure. Machinery may be positioned at its final elevation before pouring because the shrinkage is negligible. Critical alignments are maintained during machinery operation due to its high dimensional stability and resistance to creep and vibration.

Chockfast®

Red SG may be mixed with a contractor’s hoe and wheelbarrow or in a small portable mortar mixer. Precondition resin, hardener and aggregate to 18°-27°C for 48 hrs, before mixing. Thoroughly mix hardener with resin first before mixing in aggregate. Where a very flowable mix is required, the aggregate content may be reduced accordingly. However, in load bearing areas a maximum reduction to 3-1/2 bags is recommended. Please contact ITW Polymers & Fluids Technical Department if less than 3-1/2 bags are being considered.

Chockfast®

Red SG is quick curing, relative to cement grouts, but the cure is thermally gentle. This allows thick pours to be made without causing the stress cracks often associated with a hot-curing epoxy grout. Chockfast® Red SG may be used in thicknesses greater than 25mm, however, individual pours should generally not exceed 100mm in

Product specification sheet

Manufacturer

Epirez

Epirez was founded in 1955 and the first product formulations pioneered the Australian development of epoxy based adhesives and coatings for use on concrete. Since then, Epirez has continued to break new ground in epoxy technology for architects, engineers, consultants,