Densopol 60 & 60HT Tape
A cold applied, synthetic fabric reinforcement coated with rubber bitumen adhesive and backed with a PVC film
Description
Densopol 60 & 60 HT is a cold-applied, synthetic fabric reinforcement coated with rubber bitumen
adhesive and backed with a PVC film.
Uses
For the corrosion protection of buried or immersed pipes and fittings. Used for external joint
sealing to prevent backfill infiltration in concrete pipes, culverts and crown units. The tapes can be
applied by hand to weld joints, bends, bare pipe lengths and pipe fittings.
Features
- Applied to marginally prepared surfaces (SSPC SP 2-3)
- Cold applied
- Good comformability
- Good impact resistance
- Excellent adhesion to pipe and self
- Excellent resistance to cathodic disbonding
- Compatible with common pipe coatings
Application
Prepare steel to St2 (power brushed)/AS 1627 P.2 (minimum). Surface must be clean, dry and
free of grease. Apply a thin film of Denso Primer D to all surfaces to be protected and allow to dry.
Peel back the interleaving and apply the adhesive side of the tape to the primed surface and press down.
Apply the tape spirally with enough tension to make it conform. Remove interleaving as wrapping
proceeds. Overlap each turn by 55% to achieve double thickness.
Irregular surfaces such as valves, flanges, etc., may require the use of Denso Bitumen Mastic,
Denso Mastic or Denso Profiling Mastic. Refer to the product sheets for these specific products for
information on application and selection.
Product specification sheet
Densopol 60 & 60HT Tape product specification sheet opens in a new windowManufacturer
Denso
